Mailing List archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[linux-dvb] Re: Re[4]: Siemens dvb network activator
As i know latest dvbtune has error to path to dvb network device.
Check it(path to this device) on sources.
Second problem as i have, it's when i activate interface, it receive ALL
traffic on selected PID.
Maybe it caused by my too high symbolrate ISP :)
On Fri, 29 Nov 2002 16:59:16 +0100, Slawek Orzechowski wrote
> Hello Denis,
>
> Friday, November 29, 2002, 1:27:53 PM, you wrote:
>
> D>>> Thursday, November 28, 2002, 8:35:11 PM, you wrote:
> SO>>>> Can someone send me this siemens_dvb_network_activator-0.1.tgz
>
> SO>> I downloaded latest drivers
> SO>> and dvbtune from CVS. Drivers compile and load fine, but
> dvbtune gives SO>> me an error
>
> D> Did You compile dvbtune with make NEWSTRUCT=1 command?
>
> Yes I did. There is a line NEWSTRUCT=1 in the Makefile.
>
> Here is what i get when i run dvbtune:
> [root@komputer dvbtune]# ./dvbtune -f 12722000 -s 22000 -p h -n 451
> Using DVB card "Alps BSRV2"
> tuning DVB-S to L-Band:1073891624, Pol:H Srate=22000000, 22kHz=off
> polling....
> Getting frontend event
> FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI
FE_HAS_SYNC
> Event: Frequency: 1434500
> SymbolRate: 22000000
> FEC_inner: 5
> Bit error rate: 0
> Signal strength: 30840
> SNR: 52685
> FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER
> FE_HAS_VITERBI FE_HAS_SYNC Failed to open DVB NET DEVICE
>
> I have a Skystar 1 rev 1.3, my system is Mandrake 9.0 with kernel
> 2.4.19 compiled by me. I2C and Video4Linux compiled as modules.
>
> Regards,
> Slawek
>
> --
> Info:
> To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe
> linux-dvb" as subject.
--
PlanetSky Technical Support
email: support@planetsky.com
--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.
Home |
Main Index |
Thread Index