Look like the driver is loading and registering the frontend but no joy
using ztap.
Robert
#dmesg
i2c-core.o: i2c core module version 2.8.1 (20031005)
Linux video capture interface: v1.00
bttv: driver version 0.9.12 loaded
bttv: snapshot date 2004-01-21
bttv: using 4 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 02:0b.0, irq: 23, latency: 64, mmio: 0xfbefc000
bttv0: detected: Nebula Electronics DigiTV [card=104], PCI subsystem ID
is 0071:0101
bttv0: using: Nebula Electronics DigiTV [card=104,insmod option]
bttv0: gpio: en=00000000, out=00000000 in=00ff48cb [init]
bttv0: using tuner=-1
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv: Bt8xx card found (1).
bttv1: Bt878 (rev 17) at 02:0a.0, irq: 22, latency: 64, mmio: 0xfbefe000
bttv1: subsystem: 1461:0761 (UNKNOWN)
please mail id, board name and the correct card= insmod option to
kraxel@bytesex.org
bttv1: using: *** UNKNOWN/GENERIC *** [card=0,autodetected]
bttv1: gpio: en=00000000, out=00000000 in=009c004d [init]
bttv1: using tuner=-1
bttv1: i2c: checking for MSP34xx @ 0x80... not found
bttv1: i2c: checking for TDA9875 @ 0xb0... not found
bttv1: i2c: checking for TDA7432 @ 0x8a... not found
bttv1: registered device video1
bttv1: registered device vbi1
bt878: AUDIO driver version 0.0.0 loaded
bt878: Bt878 AUDIO function found (0).
bt878(0): Bt878 (rev 17) at 02:0b.1, irq: 23, latency: 64, memory:
0xfbefd000
bt878: Bt878 AUDIO function found (1).
bt878(1): Bt878 (rev 17) at 02:0a.1, irq: 22, latency: 64, memory:
0xfbeff000
DVB: registering new adapter (Neb).
DVB: registering new adapter (Ave).
DVB: registering frontend 0:0 (NxtWave NXT6000)...
Can you please load the nxt6000.o module with parameter debug=1? Then
you get a message which should tell you what tunertype is used. Please
check that this is the right one.