[vdr] Re: How to setup diseqc in vdr-1.1.12

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Oliver Endriss wrote:
> 
> Klaus Schmidinger wrote:
> > Oliver Endriss wrote:
> > > Well, each line needs an *unique* Fx code
> > > Typically, you would use F0..FB for 3 satellites.
> > > Different satellites need different mini commands, but it doesn't
> > > make much sense to include the voltage/continuous tone/mini
> > > commands, since mini DiSEqC cannot be used for more than two
> > > satellites.
> > > See my other posting.
> >
> > I wonder how he was able then to use VDR 1.0.4 with just setting the
> > diseqc parameter of his channels to 0, 1 and 2, respectively. In that
> > case the resulting effect should have been just the sequence of
> > actions as I posted. Well, anyway, if it works for him with unique Fx
> > codes, that just fine.
> 
> vdr-1.0.4, dvbapi.c:
>   scmd.u.diseqc.params[0] = 0xF0 | ((Diseqc * 4) & 0x0F) | (tone == SEC_TONE_ON ? 1 : 0) | (volt == SEC_VOLTAGE_18 ? 2 : 0);
> Voltage and continous tone were encoded in bits 0 and 1, while
> the DiSEqC parameter goes into bits 2 and 3.
> These are exactly the Fx parameters I posted.

Ooops, sorry - you are of course right.

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.