[linux-dvb] patches...

Mark Sutton mes at lazo.ca
Wed Dec 21 02:11:24 CET 2005


Hi Manu,
	Thanks for posting this. I also have the same issues as Mark.
The dst_wait_dst_ready: dst wait NOT ready after 200

Although I see a different number of 250 with the v4l-dvb tree on the
newer rev of this card and and this with the older (1022A?): see below

This mail was started a few days ago, but not finished.
I just haven't had the time to try all the posibilities.

I have added your patches (there are 5?) to my tree and rebuilt.
I still get the output below, but sometimes I do get a good tune and
have dumped channel lists. I will collect the debug info and post.
Always, if the wait ready is 54 or 53,
the tune fails, good tunes are much faster ~10-12.

I have wanted to rebuild all the other tools to be sure they are not
causing problems, but I expect the tuning is still not reliable.
I have not tried with the newer rev of the card.
And unfortunatly the first Pacific storm in a long time has blown up
and moved my dish (held in place by a cinder block)
and now I can't tune anything even with a set top box.

dst_set_freq: set Frequency 1770000
dst_set_frontend: Set Frequency=[1770000]
dst_set_symbolrate: set symrate 20000000
dst_set_symbolrate: set symcalc 238312
dst_set_polarization: Polarization=[Horizontal]
dst_set_frontend: Set Symbolrate=[20000000]
dst_write_tuna: type_flags 0x16
dst_comm_init: Initializing DST.
dst_gpio_outb: mask=[ffffffff], enbb=[0001], outhigh=[0000]
rdc_reset_state: Resetting state machine
dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0000]
dst_gpio_outb: mask=[0002], enbb=[0002], outhigh=[0002]
writing [ 06 ea 01 3a 2e 80 40 e7 ]
i2c_adapter i2c-0: master_xfer[0] W, addr=0x55, len=8
bt-i2c: <W aa 06 ea 01 3a 2e 80 40 e7 >
dst_gpio_outb: mask=[ffffffff], enbb=[0000], outhigh=[0000]
i2c_adapter i2c-0: master_xfer[0] R, addr=0x55, len=1
bt-i2c: <R ab =ff >
read_dst: reply is 0xff
dst_wait_dst_ready: dst wait ready after 54
i2c_adapter i2c-0: master_xfer[0] R, addr=0x55, len=8
bt-i2c: <R ab =00 =00 =33 =00 =00 =1e =ff =b0 >
read_dst: reply is 0x0

I will repost with a better collection of debug output.
Should I post the output on a website or in the mail?

Thanks, mark









More information about the linux-dvb mailing list