[linux-dvb] Hauppauge Nexus-S v2.3

Hubert Plattfaut hfred at ploeb.de
Thu Mar 10 23:48:02 CET 2005


> Kenneth Aafløy schrieb:
> 
>> On Thursday 10 March 2005 05:10, Oliver Endriss wrote:
>>
>>> It's just a new card revision.
>>>
>>> According to 
>>> http://vdrportal.de/board/thread.php?postid=276932#post276932
>>> there is a BSBE1-502A tuner on the card. This tuner is stv0299-based,
>>> see http://www.linuxtv.org/pipermail/linux-dvb/2005-March/000386.html
>>
>>
>>
>> Ok, sounds good.
>>
>>
>>> First of all you should check whether 13V/18V voltage switching and
>>> 22kHz signal generation work. If not you have to find out how the LNBP20
>>> is wired to the GPIOs.
>>>
>>> Imho it should not be too difficult to make the driver work if you own
>>> such a card. :-(
>>
>>
>>
>> Hubert, would you mind trying cvs with the attached patch then?
> 
> 
> Kenneth,
> 
> thank you for the patch. I just updatet the cvs and ran then patch. 

As an additional test I have used the patch with the suse default dvb 
sources (dvb-1.1.0_CVS20040812-7). Quite the same results except: 
dvbscan waits much longer (about 1 minute) until it writes the error 
message. And kaxtv shows after a little bit thinking 100 % signal and 
100 % SNR in nice colors. But thats all, nothing else is found:

-----
Using DVB card "STV0299/TSA5059/SL1935 based"
tuning DVB-S to 12551000 v 22000000
inv:2 fecH:5
polling....
Getting frontend event
polling....
Getting frontend event
polling....
polling....
polling....
------

Where is the problem (the cabeling is ok, windows works)? Did I miss 
something?






More information about the linux-dvb mailing list