[linux-dvb] Pinnacle 200i

François-Xavier Payet Francois-Xavier.Payet at ens.insa-rennes.fr
Thu Mar 17 20:35:30 CET 2005


Ok, so I must be very silly

By doing just a "modprobe saa7134-dvb", dmesg gives me :

saa7130/34: v4l2 driver version 0.2.12 loaded
ACPI: PCI interrupt 0000:01:09.0[A] -> GSI 7 (level, low) -> IRQ 7
saa7134[0]: found at 0000:01:09.0, rev: 1, irq: 7, latency: 32, mmio: 
0xde001000
saa7134[0]: subsystem: 11bd:002d, board: Pinnacle PCTV 300i DVB-T + PAL 
[card=50,insmod option]
saa7134[0]: board init: gpio is cc06000
tda9885/6/7: chip found @ 0x86
tuner 3-0060: chip found @ 0xc0 (saa7134[0])
tuner 3-0060: microtune: companycode=3cbf part=42 rev=09
tuner 3-0060: microtune MT2050 found, OK
saa7134[0]: i2c eeprom 00: bd 11 2d 00 f8 f8 1c 00 43 43 a9 1c 55 d2 b2 92
saa7134[0]: i2c eeprom 10: 00 f0 04 04 ff 20 ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: 01 40 01 02 03 ff 03 01 08 ff 00 25 ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: registered device video1 [v4l2]
saa7134[0]: registered device vbi1
saa7134[0]: pinnacle 300i dvb setup
DVB: registering new adapter (saa7134[0]).
DVB: registering frontend 0 (Zarlink MT352 DVB-T)...

Now, can anyone gives me a little tip on where to go now (software to use, 
link to an howto, ...)

Thanks

FX




More information about the linux-dvb mailing list