[linux-dvb] Two card config question

Philip Prindeville philipp_subx at redfish-solutions.com
Sun Oct 30 17:16:56 CET 2005


Manu Abraham wrote:

> Philip Prindeville wrote:
>
>>
>> Here's my logs, but as I said, I had to run the "modprobe bttv0" by 
>> hand...
>>
>> Oct 29 18:17:47 tuner kernel: IrDA: Registered device irda0 (via-ircc)
>> Oct 29 18:17:47 tuner kernel: Linux video capture interface: v1.00
>> Oct 29 18:17:47 tuner kernel: cx2388x dvb driver version 0.0.4 loaded
>> Oct 29 18:17:47 tuner kernel: cx88[0]: subsystem: 7063:3000, board: 
>> pcHDTV HD3000 HDTV [card=22,autodetected]
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKB] enabled 
>> at IRQ 12
>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 12 as level-triggered
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.2[A] -> 
>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12
>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: found at 0000:00:14.2, rev: 
>> 5, irq: 12, latency: 32, mmio: 0xdf000000
>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: cx2388x based dvb card
>
>
>
> You have the frontend for the cx88 ..
>
>> Oct 29 18:17:47 tuner kernel: DVB: registering new adapter (cx88[0]).
>> Oct 29 18:17:47 tuner kernel: DVB: registering frontend 0 (pcHDTV 
>> HD3000 HDTV)...
>> Oct 29 18:17:47 tuner kernel: cx2388x v4l2 driver version 0.0.4 loaded
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.0[A] -> 
>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12
>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: found at 0000:00:14.0, rev: 
>> 5, irq: 12, latency: 32, mmio: 0xde000000
>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: chip found @ 0xc2 (cx88[0])
>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: type set to 52 (Thomson 
>> DDT 7610 (ATSC/NTSC))
>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device video0 [v4l2]
>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device vbi0
>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device radio0
>> Oct 29 18:17:47 tuner kernel: bttv: driver version 0.9.15 loaded
>> Oct 29 18:17:47 tuner kernel: bttv: using 8 buffers with 2080k (520 
>> pages) each for capture
>> Oct 29 18:17:47 tuner kernel: bttv: Bt8xx card found (0).
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.0[A] -> 
>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10
>> Oct 29 18:17:47 tuner kernel: bttv0: Bt878 (rev 17) at 0000:00:13.0, 
>> irq: 10, latency: 32, mmio: 0xe0001000
>> Oct 29 18:17:47 tuner kernel: bttv0: detected: ChainTech digitop 
>> DST-1000 DVB-S [card=113], PCI subsystem ID is 270f:fc00
>> Oct 29 18:17:47 tuner kernel: bttv0: using: Twinhan DST + clones 
>> [card=113,autodetected]
>> Oct 29 18:17:47 tuner kernel: bttv0: using tuner=4
>> Oct 29 18:17:47 tuner kernel: bttv0: add subdevice "dvb0"
>> Oct 29 18:17:47 tuner kernel: bt878: no version for "struct_module" 
>> found: kernel tainted.
>> Oct 29 18:17:47 tuner kernel: bt878: AUDIO driver version 0.0.0 loaded
>> Oct 29 18:17:47 tuner kernel: bt878: Bt878 AUDIO function found (0).
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.1[A] -> 
>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10
>> Oct 29 18:17:47 tuner kernel: bt878(0): Bt878 (rev 17) at 00:13.1, 
>> irq: 10, latency: 32, memory: 0xe0002000
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKD] enabled 
>> at IRQ 7
>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 7 as level-triggered
>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:10.3[D] -> 
>> Link [LNKD] -> GSI 7 (level, low) -> IRQ 7
>> ...
>> Oct 29 19:20:29 tuner kernel: or51132: Waiting for firmware 
>> upload(dvb-fe-or51132-vsb.fw)...
>> Oct 29 19:20:39 tuner kernel: or51132: Version: 10001134-19430000 
>> (113-4-194-3)
>> Oct 29 19:20:39 tuner kernel: or51132: Firmware upload complete.
>> Oct 29 19:21:17 tuner kernel: DVB: registering new adapter (bttv0).
>> Oct 29 19:21:17 tuner kernel: dst_get_device_id: Recognise [DST-03T]
>> Oct 29 19:21:17 tuner kernel: DST type : satellite
>> Oct 29 19:21:17 tuner kernel: DST type flags : 0x2 ts204 0x4 symdiv 
>> 0x10 firmware version = 2
>> Oct 29 19:21:17 tuner kernel: DVB: registering frontend 1 (DST DVB-S)...
>>
>
> You have the dst too ..
>
>>
>> Any more suggestions?
>>
>
> Now what's the problem.. ?
>
> Manu
>

Well, it's not installing "dst" on reboot.  I have to do "modprobe 
bttv0" and "modprobe bttv1"
by hand...

-Philip




More information about the linux-dvb mailing list