[linux-dvb] KNC1 DVB-C Plus + CI - still failing :(
c.burgalat at broadcastavenue.com
Thu Jun 29 14:08:04 CEST 2006
I confirm that my KNC1 DVB-C Plus card works with the CI module.
I had to change the driver code to allow initializing CI event if it sees a
saa7113 chip. I was then able to descramble channels with an ASTON VIACCESS
I did not test the S-Video input.
Le Jeudi 29 Juin 2006 00:24, Andrew de Quincey a écrit :
> On Wednesday 28 June 2006 23:20, Bastian Friedrich wrote:
> > Hi,
> > On Wednesday 28 June 2006 23:40, you wrote:
> > > Looking at the most likely card on KNC1.com, the problem is the card
> > > supports analogue inputs *AND* a CI module.
> > In fact the card probably does support some analogue input via a S-Video
> > connector. I don't have the slightest idea why I should want this, but
> > anyway... I have it ;)
> > I was (obviously falsely) believing that the difference between the
> > Plus- and non-Plus cards was the existence (or non-existence,
> > respectively) of a CineView connector, but yes, the Plus version has
> > some analogue _and_ a CI connector.
> > > Previous cards didn't
> > > support this, so the driver is set up to assume if it sees an saa7113
> > > chip (for the extra inputs), then the card cannot have a CI module.
> > Well... This is no longer true :(
> > > This would have to be investigated by trying combinations out to see
> > > what works - or else by asking the manufacturer for information.
> > If there is any additional help I can provide - I'll be glad to help :)
> I'm trying to find out if I can get info...
> Also, I might be able to figure it out if I had remote ssh access to the
> card for a while to see if I can work out what is needed.
> linux-dvb mailing list
> linux-dvb at linuxtv.org
More information about the linux-dvb