[linux-dvb] Twinhan DTV TER-CI 3030 Mantis DVB-T

Andreas Vinsander andreas at vinsander.se
Wed Nov 15 16:05:45 CET 2006


Hi!

I recently subscribed to this maillist and have since done some reading 
up on the posts. And found this from the "Mantis 
VP-1027/VP-1033/VP-1034/VP-2033/VP-3033"-thread:

--------------
Subject: Re: [linux-dvb] Mantis VP-1027/VP-1033/VP-1034/VP-2033/VP-3033
From: Manu Abraham
Date: Sat, 07 Oct 2006 05:11:49 -0700

Lauri Tischler wrote:
 >
 > Does this apply also to these cards
 > - Twinhan DTV TER-CI 3030 Mantis DVB-T
 > - Twinhan DTV TER-CI 3040 DVB-T PCI
 > - Twinhan DTV SAT-CI 1030 DVB-S PCI

No. The dst module supports these cards.

Manu
----------------

I have one of those Twinhan DTV TER-CI 3030 Mantis DVB-T pci cards, but 
the dst module (from gentoo package v4l-dvb-hg-0.1-r2, which seems to 
pull the source via hg from the dvb repository) doesn't seem to 
recognize the card. dmesg and logfiles shows that the modules are loaded 
but they don't find a bt8x8 chip and thus no /dev/dvb/ entries are 
created (udev-103). I have tried the modules supplied by the kernel 
gentoo-sources-2.6.18-r2 (do I need to try vanilla 2.6.19-rc5?) as well, 
with the same results.

I am running 64bit Linux on an Athlon64 X2 3800+ stuffed into an ASUS 
M2NPV-VM motherboard. Both PCI slots are used, one for the Twinhan card 
and the other for an atheros based WiFi card (which works alright btw).

I provide some lspci & pcimodules output down below, what else can I do 
to find out what goes wrong here? Is it possible that Manu missed 
something when he stated that this card was supported by the dst module?


# lspci -vv
...
04:08.0 Multimedia controller: Twinhan Technology Co. Ltd Mantis DTV PCI 
Bridge Controller [Ver 1.0] (rev 01)
         Subsystem: Twinhan Technology Co. Ltd Unknown device 0024
         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
         Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium 
 >TAbort- <TAbort- <MAbort- >SERR- <PERR-
         Latency: 32 (2000ns min, 63750ns max)
         Interrupt: pin A routed to IRQ 5
         Region 0: Memory at fdaff000 (32-bit, prefetchable) [size=4K]

...

# lspci -nv
04:08.0 0480: 1822:4e35 (rev 01)
         Subsystem: 1822:0024
         Flags: bus master, medium devsel, latency 32, IRQ 5
         Memory at fdaff000 (32-bit, prefetchable) [size=4K]

# pcimodules
nvidia
i2c-nforce2
snd-hda-intel
ath_pci

No sign of any DVB drivers compliant with the card at 04:08.0

I have quite good programming skills (C++, C) and would be happy to help 
out as much as my wife allows me ;-)

BR,
/Andreas



More information about the linux-dvb mailing list