[linux-dvb] [PATCH] DIB3000MC and NOVA T USB2

José Oliver Segura primijos at gmail.com
Thu Nov 23 22:42:03 CET 2006


       Well, the channels in my channels channels.conf have a defined
FEC_ (no auto), the only _AUTO (and, in all of them) is
INVERSION_AUTO.

       Thanks anyway. I'm just trying to figure out why that strange
behaviour in some channels and the "magic" of tunning to the 0 ber/unc
channel.

       I'll wait the "antenna guy", who must review my antenna
installation someday next week anyway :)

       Best,
       Jose


On 11/23/06, Mario Rossi <mariofutire at googlemail.com> wrote:
> My patch is only useful when trying to tune a transponder using some
> of the XXX_AUTO settings. For instance FEC_AUTO instead of FEC_2_3.
> In this case dib3000mc is clever enough to figure out which FEC_ to
> use to get a correct tuning.
> IMHO, in your case, I'm afraid but it should make no difference.
>
> On 11/23/06, José Oliver Segura <primijos at gmail.com> wrote:
> >        Hi Mario,
> >
> >        I'd like to ask you a question regarding the dib3000mc patch: I
> > have almost no idea of dvb (thus, SEQ, ***_AUTO, etc, sounds strange
> > to me :)) , but I have a WinTV nova-t stick, that works OK under
> > windows and has some problems (lots of "ber" and some "unc" with a
> > signal of about 7000/8000) under linux (and it uses dib300mc module),
> > and I was wondering if the modifcations you are proposing with your
> > patch could help (I mean: does it improve signal reception in someway?
> > [I'm assuming ber/unc are due to signal reception, which maybe is too
> > much assumption?])
> >
> >        The behaviour of the stick with linux is very strange (sadly:
> > windows works perfect with hauppaugge drivers). Under Linux, I've
> > found that for these channels for what I get a high number of ber/unc
> > (thus: impossible to watch tv), if I tune (tzap) to another specific
> > channel (a channel that has a signal between a000-a200, ber=0, unc=0),
> > and then I try to zap back to the channel with high ber/unc, these
> > values are 0 (or almost) so, I can watch that channel... but... after
> > some time (minutes?), the numbers start to get higher, and back again
> > to "unwatchable" TV :)
> >
> >        As I told, I have no idea about what _guard, seq, etc. mean,
> > sorry if this question is completely silly
>



More information about the linux-dvb mailing list