[linux-dvb] Cinergy 1200 DVB-C and Xubuntu 6.10 - should it work?
tingox at gmail.com
Mon Jan 8 17:51:51 CET 2007
On 1/8/07, e9hack <e9hack at googlemail.com> wrote:
> I'm using a Cinergy 1200 DVB-C (Suse 10.1, kernel 18.104.22.168, current dvb
> drivers from linuxtv.org) without any problems. It seems, that the DVB
> card shares its interrupt with another card/device:
> [17179586.112000] ACPI: PCI Interrupt 0000:00:1f.5[B] -> GSI 17 (level, low) -> IRQ 209
> [17179586.460000] ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 17 (level, low) -> IRQ 209
> This may be the problem. You should remove the other card (if it is
> possible) and try it again.
Hmm, it sems that 00:1f.5 is the (built-in) sound chip:
root at kg-htpc:~# lspci -s 00:1f.5 -vvv
00:1f.5 Multimedia audio controller: Intel Corporation 82801DB/DBL/DBM
(ICH4/ICH4-L/ICH4-M) AC'97 Audio Controller (rev 02)
Subsystem: Micro-Star International Co., Ltd. Unknown device 5570
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin B routed to IRQ 209
Region 0: I/O ports at e000 [size=256]
Region 1: I/O ports at dc00 [size=64]
Region 2: Memory at dff7ba00 (32-bit, non-prefetchable) [size=512]
Region 3: Memory at dff7b900 (32-bit, non-prefetchable) [size=256]
Capabilities:  Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Which makes it hard to remove it. Is there a way to force another irq for it?
Interrupts are controlled by ACPI, and I don't know how to change /
force irq's under Linux.
More information about the linux-dvb