[linux-dvb] DISEqC problem: after switching to port 1, no switch works anymore

Remy Bohmer mythtv.bohmer at gmail.com
Wed Jan 31 12:46:33 CET 2007


Hello Gregoire,

Not really...
It turned out that the problem is receiver card related.
Switching the LNB's also moved the problem to another switch-port.

So, the card had problems with just one single LNB's. When it switches
to that LNB, it cannot switch back to another LNB.

I have to power off the PC to make it all work again... (until I
switch to that LNB...)

Maybe some thing on the card is not properly reset during a switch, I
don't know...

An older version of the same card (Skystar 1 CI rev.1.0) works
properly, (Skystar 1 CI rev 3.0) gives this problem.


Kind Regards,

Remy


2007/1/30, Gregoire Favre <Gregoire.Favre at gmail.com>:
> On Fri, Jan 12, 2007 at 12:53:03PM +0100, Remy Bohmer wrote:
> > Hello,
> >
> > I have discovered a strange problem:
> > I have a DVB-S system, with a VP1030 clone receiver card (Technisat Skystar
> > 1 CI v3)
> > Card works fine without problems, except when I use the DISEqC switch.
>
> Hello,
>
> did you solve your problem ?
> --
> Grégoire FAVRE  http://gregoire.favre.googlepages.com  http://www.gnupg.org
>
> _______________________________________________
> linux-dvb mailing list
> linux-dvb at linuxtv.org
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
>
>



More information about the linux-dvb mailing list