[linux-dvb] DVB-S2 scan doesn't get provide full output.

Patrick Bulteel linuxtv at bulteel.org
Sun Nov 4 01:51:38 CET 2007


Quoting Manu Abraham <abraham.manu at gmail.com>:

> Patrick Bulteel wrote:
> > I have a TT3200 and I'm running the most current code from Manu's
> Multiproto
> > tree. I also have the szap and scan that have been patched to work with
> the
> > Multiproto stb0899 driver. The problem that I'm encountering seems to be
> that
> > when I ran scan I did get a dump of channels (Astra 28.2E) but... I can't
> tune
> > to any of them.
> > 
> > There's a test.conf file with the scan file that includes some channels,
> but
> > although I tune to them, they're not named correctly. I get the GOD
> Channel, GOD
> > Europe, etc instead of the one that I'm trying to get. 
> > 
> > I looked though my scan file and I see the following:
> > 
> > My scan file...
> > BBC FOUR:10773:h:0:0:5300:5301:6316
> > GOD Europe:11680:v:0:0:2311:2312:51103
> 
> This is the output of scan ?, or did you create it manually by hand ?
> 
> 
> Manu
> 

This is the output of scan. I just copied a few entries - the final file had
1100+ entries all without a symbolrate. I went to the http://www.lyngsat.com
site and manually added the symbolrate to a few entries and they work fine (and
are the correct channel, etc.)

I grabbed the scan.tar.bz2 file again in case there were changes, but I got the
same thing. 

--
Patrick




More information about the linux-dvb mailing list