[linux-dvb] DVICO NANO Australia

Michael Krufky mkrufky at linuxtv.org
Thu Nov 8 04:55:08 CET 2007


Collier Family wrote:
> I have a  DVICO NANO but I am having the same troubles others had in June. It appears it is not being recognised as being cold. 
> 
> I have followed the instructions at http://fremnet.net/article/228/dvico-fusionhdtv-dual-digital-4-under-linux and all went well except the frontend not set. dmesg follows
> 
> usb 5-8: new high speed USB device using ehci_hcd and address 9
> usb 5-8: configuration #1 chosen from 1 choice
> dvb-usb: found a 'DViCO FusionHDTV DVB-T NANO2' in warm state.
> dvb-usb: bulk message failed: -22 (2/0)
> dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
> DVB: registering new adapter (DViCO FusionHDTV DVB-T NANO2)
> dvb-usb: bulk message failed: -110 (1/0)
> dvb-usb: bulk message failed: -110 (3/0)
> dvb-usb: bulk message failed: -110 (3/0)
> dvb-usb: bulk message failed: -110 (5/0)
> dvb-usb: no frontend was attached by 'DViCO FusionHDTV DVB-T NANO2'
> dvb-usb: DViCO FusionHDTV DVB-T NANO2 successfully initialized and connected.
> 
> Is there any other information that may help I am running vanilla 2.6.23.1 kernel on Scientific linux 5.0
> 
> Thanks a lot for the work so far. 

The DVB-T NANO2 does not require the bluebird firmware -- the fx2 boots it from the eeprom.  So, the device does not have a "cold" state.  The only firmware that you need for it is the xc3028 firmware that was used in Markus' xc3028 kernel driver.

However, there is alternate firmware required for the xc3028 for use in Australia.  I assume that you already have that.

-Mike



More information about the linux-dvb mailing list