[linux-dvb] Avermedia HC82 express card
james.ellis at gmail.com
Mon Jun 23 14:15:09 CEST 2008
hi, sorry for the resend, just wondering whether anyone had some input on this
DVB express card ?
> I recently got a new laptop and this express card was included in the
> package. I'm interested in support for it in Linux, although given I didn't
> ask for it, I won't be too miffed if it cannot yet be supported.
> I think the main problem is getting the firmware...
> Here is what I can gather...
> Plugging the express card in (after "pciehp pciehp_force=1") shows:
> ==> /var/log/syslog <==
> Jun 11 23:14:02 box kernel: [34224.509805] pciehp: Card present on
> ==> /var/log/messages <==
> Jun 11 23:14:03 box kernel: [34225.206518] program_fw_provided_values:
> Could not get hotplug parameters
> Windows shows the card details as:
> Avermedia HC82 Express-Card Hybrid Analog
> Output of lspci -vvnn
> 0d:00.0 Multimedia controller : Philips Semiconductors Unknown device
> [1131:7160] (rev 03)
> Subsystem: Avermedia Technologies Inc Unknown device [1461:0555]
> Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR- FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Interrupt: pin A routed to IRQ 0
> Region 0: Memory at f9c00000 (64-bit, non-prefetchable) [disabled]
> Capabilities:  Message Signalled Interrupts: Mask- 64bit+
> Queue=0/5 Enable-
> Address: 0000000000000000 Data: 0000
> Capabilities:  Express Endpoint IRQ 0
> Device: Supported: MaxPayload 128 bytes, PhantFunc 0,
> ExtTag- Device: Latency L0s <256ns, L1 <1us
> Device: AtnBtn- AtnInd- PwrInd-
> Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
> Device: RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop-
> Device: MaxPayload 128 bytes, MaxReadReq 128 bytes
> Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s L1, Port
> 1 Link: Latency L0s <4us, L1 <64us
> Link: ASPM Disabled RCB 128 bytes CommClk- ExtSynch-
> Link: Speed 2.5Gb/s, Width x1
> Capabilities:  Power Management version 2
> Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> Capabilities:  Vendor Specific Information
> Installing the driver from Dell
>&releaseid=R175809&formatcnt=1&libid=0&fileid=239014) in Windows gives the
> following files, that look like drivers. Are their any others that could be
> candidates ?
> The question then is how can the firmware be installed in linux ? I've read
> the linux-dvb wiki but am still unsure.
> Any help appreciated..
More information about the linux-dvb