[linux-dvb] Geniatech DVB-S Digistar

[Wayne and Holly]

I'll try again,
Is anyone using the subject card without any problems?  I read a handful
of articles stating that the card was supported in Linux out of the box,
but my playback is unwatchable.  I doubt it is my system as a 2.1GHz
dual core CPU and 4GB DDR2 should be overkill.  I was surprised to see
"Conextant Unknown Device [14f1:0084]" for the lspci subsystem
considering it is supported by the cx88 module but don't know if this is
an issue.  I'm guessing I may need to change some of my settings but
have not been able to find any documentation that gives any clues for
where to start.

Here is my lspci -vvn output:

01:06.0 0400: 14f1:8800 (rev 05)
Subsystem: 14f1:0084
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 20 (5000ns min, 13750ns max), Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 18
Region 0: Memory at fa000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

01:06.2 0480: 14f1:8802 (rev 05)
Subsystem: 14f1:0084
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (1500ns min, 22000ns max), Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 18
Region 0: Memory at f9000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [4c] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Cheers
Wayne