[linux-dvb] Leadtek DTV1000s Development Help

hermann pitton hermann-pitton at arcor.de
Fri Sep 26 03:23:46 CEST 2008


Am Freitag, den 26.09.2008, 02:02 +0100 schrieb Mitchell, J.G.:
> Hello Everyone,
> 
> I bought this card some months back now and I did a bit of research to find out to my dissapointment that it is not supported under Linux. However, I am about to embark on an Embedded Systems Engineering degree and I thought that maybe, developing a device driver for this card would be a good start? Now I have found that this card incorporates the SAA7130, TDA10048 and TDA18271.
> 
> I currently run ArchLinux and have some programming experience, I am reading a couple of books at the moment such as Programming Embedded Systems and C Programming (K&R) so I have a good base to work from and can refer to the books if i need some technical help.
> 
> At the moment I am at a loss to where to start, would somebody be able to point me in the right direction to start working on this project?
> 
> Regards,
> Jack.
> 

Hi Jack,

you have some new combinations here.

To load the saa7134 with i2c_scan=1 could be a start.

"modinfo saa7134"

Cheers,
Hermann





More information about the linux-dvb mailing list