[vdr] femon 1.6.3 - some remarks

[Goga777]

> > I have installed femon 163 with my vdr 170. There's some remarks concerning of h264 channels
> > no any information in CoderateH  (I can see only ---)
> 
> The plugin doesn't support multiproto/S2API and therefore channels using 
> new coderates like "9/10" are shown as data invalid ("---").

ok, I will check with another fec 


> > in BITRATE field I can see only ---(6 Mbit/s)
> > FRAME RATE - ---
> > Codec - H264
> 
> I don't have any access to H.264 (or HE-AAC) streams so support for 
> these are more like academic. The bitrate, framerate, and scan type 
> aren't parsed at the moment as my blindly written code didn't worked 
> right from the start. This particular piece of code was hidden behind 
> #if pragmas in femonh264.c, so it would be nice, if someone could take a 
> look at it and send be a patch.

--------------------------------------------------------------
|## Channel Name ########################## [AR][VF][A/DD][D]|
|[==== Signal Strength in % ==============|=================]|
|[==== Signal-to-Noise Ratio in % ========|=================]|
| STR: #0000 (0%)       BER: #00000000       Video: 0 Mbit/s |
| SNR: #0000 (0%)       UNC: #00000000       Audio: 0 kbit/s |
| [LOCK]     [SIGNAL]     [CARRIER]     [VITERBI]     [SYNC] |
--------------------------------------------------------------


I can see without any problem video/audio bitrate on the top right of OSD (that's why the bitrate is parsed at the
moment correctly) , but I don't see video/audio bitrate below in OSD

> > Audio stream #0 ()
> > Codec - ---
> > Channel Mode - ---
> > Bitrate - ---
> > Sampling Frequency - ---
> 
> This looks also ok. Non-existent audio pid provides no stream 
> information. I guess your channel contained only ac3 audio or no audio 
> at all.

again -  I can see without any problem video/audio bitrate on the top right of OSD (that's why the bitrate is parsed at the
moment correctly) , but I don't see video/audio bitrate below in OSD of femon

> > If I try to switch channel up/down with OSD femon menu my vdr will hang up
> 
> I cannot reproduce this on my setup. Please, use vanilla (or _only_ 
> liemikuutio patched) VDR for testing. There 2 active femon users (me 
> and my friend), so the testing has been quite light - at least I 
> haven't got any bug/success reports from other users. :)

the same problem was described on our Russian-vdr forum from other vdr user. It wasn't happened on previous femon versions.
I will not be able to run vanilla vdr 170 because I have s2api drivers 


Goga