Mailing List archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[linux-dvb] Re: Low symbol rates with gVideo & drv0.82
I think that hardware have problem tunning low symbol rate signal. Low symbol signal need more strong signal power than high
symbol rate signal.
-----Original Message-----
From: linux-dvb-bounce@linuxtv.org [mailto:linux-dvb-bounce@linuxtv.org]On Behalf Of Andrei Boros
Sent: Thursday, September 20, 2001 3:36 PM
To: linux-dvb@linuxtv.org
Subject: [linux-dvb] Low symbol rates with gVideo & drv0.82
I have a Technisat SkyStar1 DVB card and I just aquired an antenna
positioner. So I tried to see what digital TV I can receive.
I ran into a problem : all TV stations on all satellites I tried that
have a low symbol rate (below 10000) did not work, although I could
measure signal strenght to be adequate.
Using sdb, it reports 6.7-6.9dB which is about the same I can see for
most stations visible on HOTBIRD and have symbol rates of 27500, or
Astra 1 with 27500 or 22000.
Is this a problem of gVideo ? Signal strength ? Drivers ?
I know the specs of the DVB card say it can work with symbol rates
between 1 and 45MS/s
Thank you.
--
ing. Andrei Boros
mailto:andrei@srr.ro / +40-1-303-1865
Centrul pt. Tehnologia Informatiei
Societatea Romana de Radiodifuziune
--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.ú¢éì¹»®&Þ±éÝjf¢–Ú%ŠËZ®X§»o¢¸0ŠØnžË›±Êâmébžì]½¶¬²æãyË
Home |
Main Index |
Thread Index