[linux-dvb] Re[4]: Siemens dvb network activator

[Slawek Orzechowski <slawek@sorzech.no-ip.com>]

Hello Denis,

Friday, November 29, 2002, 1:27:53 PM, you wrote:

D>>> Thursday, November 28, 2002, 8:35:11 PM, you wrote:
SO>>>> Can someone send me this siemens_dvb_network_activator-0.1.tgz

SO>> I downloaded latest drivers
SO>> and dvbtune from CVS. Drivers compile and load fine, but dvbtune gives
SO>> me an error

D> Did You compile dvbtune with make NEWSTRUCT=1 command?

Yes I did. There is a line NEWSTRUCT=1 in the Makefile.

Here is what i get when i run dvbtune:
[root@komputer dvbtune]# ./dvbtune -f 12722000 -s 22000 -p h -n 451
Using DVB card "Alps BSRV2"
tuning DVB-S to L-Band:1073891624, Pol:H Srate=22000000, 22kHz=off
polling....
Getting frontend event
FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC
Event:  Frequency: 1434500
        SymbolRate: 22000000
                FEC_inner:  5
                Bit error rate: 0
                Signal strength: 30840
                SNR: 52685
                FE_STATUS: FE_HAS_SIGNAL FE_HAS_LOCK FE_HAS_CARRIER FE_HAS_VITERBI FE_HAS_SYNC
                Failed to open DVB NET DEVICE

I have a Skystar 1 rev 1.3, my system is Mandrake 9.0 with kernel
2.4.19 compiled by me. I2C and Video4Linux compiled as modules.

Regards,
Slawek                          



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.