[linux-dvb] Re: AW: AW: mplayer divx rendering

[Alessio Sangalli <alesan@manoweb.com>]

Stephan Bieker wrote:

> I searched three days to find the solution...:-)

I arrived to that conclusion befause I searched on the internet and I 
realized that it was the driver of the frontend (fe!) so it had to do 
with the tuner. As my card had no cable attached, I understood it could 
have been like this.

I have another problem however: as I use astra only on the second LNB, I 
have to start VDR (or another program) to tune the card on a hotbird 
channel, THEN I can use mplayer.


> >in the right place, I attached the cable back and I don't have such a
> >process anymore.
>
>
> You have it, but it don't waste so much cpu-time.
yes, that's want I wanted to say.


> I think, the author should prevent this zig-zag behavior if the card 
> doesn't
> get any signal over a long time.

Also because I think very little people in the world use the old astra 
satellites, outside germany.



> I'm going crazy with mplayer too. I can't get mplayer 0.90rc3 with the
> mplayer.sh006a to play divx over my dvb for a whole film.
> When i start it, it works fine. After 5 or 10 Minutes it becomes very slow
> and "ruckelig". I really tried everything and i cant figure it out.

My setup is even 'powerful' and no nfs: athlon 2000+ and hard disk. 
mpeg2 replay is just fine.

Should I try with old, non-newstruct drivers?

bye
as



--

How to build a lirc receiver
http://www.manoweb.com/alesan/lirc




--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.