[linux-dvb] Re: New Hauppauge Nova-T board not working

[Lauri Tischler <lwgt@iki.fi>]

Hamish Moffatt wrote:
> On Wed, Feb 09, 2005 at 08:07:37PM +0200, Lauri Tischler wrote:
>
> > But this is what I get
> > ----------
> > cx2388x v4l2 driver version 0.0.4 loaded
> > ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 19 (level, low) -> IRQ 19
> > cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T 
> > [card=18,autodetected]
> > cx88[0]/0: found at 0000:00:0a.0, rev: 5, irq: 19, latency: 32, mmio: 
> > 0xe6000000
> > cx88[0]/0: registered device video1 [v4l2]
> > cx88[0]/0: registered device vbi0
> > cx2388x blackbird driver version 0.0.4 loaded
>
> You have the wrong driver (cx88-blackbird) loaded.
> Unload it (rmmod) and load the dvb driver (cx88-dvb) instead.
Ummm..  Dont have cx88-dvb, I'm quite sure that I have dotted
everything related to cx88 in kernel menuconfig.  Gotta check again.
Maybe the greatest and latest 2.6.11-rc3-bk5 is brokken.

This hotplug thingy is horrible, need to disable most of the stuff
there, except firmware.agent.
Must have been cooked up by some renegade from MS.