[vdr] VDR + mplayer and lirc

["Marco" <marco@noope.de>]

I try to enable lirc support on my mplayer. First i tried mplayer only (without vdr running).
The ony one message i get on the start of mplayer about lirc is:
"Setting up lirc support..."

But i can not send any commands with my remote. The ~/.lircrc:

begin
remote = Hauppauge
prog = mplayer_lirc
button = OK
repeat = 1
config = FFWD
end

It is only one button to test configured.

The /etc/lirc.conf is:

begin remote

  name  Hauppauge
  bits           13
  flags SHIFT_ENC
  eps            30
  aeps          100

  one           950   830
  zero          950   830
  plead         960
  gap          89584
  repeat_bit      2

      begin codes
          Red                       0x000000000000100F
          Green                    0x000000000000100C
          OK              0x000000000000102E
          UP                      0x0000000000001020
          Down                      0x0000000000001021
          Left                     0x0000000000001011
          Right                    0x0000000000001010
          Yellow                     0x000000000000100D
          Blue                   0x0000000000001022
          Volume+                        0x0000000000001001
          2                        0x0000000000001002
          Volume-                        0x0000000000001003
          4                        0x0000000000001004
          5                        0x0000000000001005
          6                        0x0000000000001006
          7                        0x0000000000001007
          8                        0x0000000000001008
          9                        0x0000000000001009
          0                        0x0000000000001000
          Back               0x000000000000101E
          Menu                 0x0000000000001026
      end codes

end remote


What is wrong on my lirc configuration with mplayer ? The remote works greate with vdr.


Thanks 

Marco