[vdr] Re: strange problem: segmentation fault

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Tobias.Stoetter@btignite.de wrote:
> 
> Hi all,
> 
> I have an vdr-0.96 running since a couple of months without any problems
> (thank you Klaus). But since yesterday I have a strange problem.
> vdr is starting but some seconds later it dies and tells me on the command
> line:
> # Segmentation fault
> Everything seems to be all right. I even can switch channels or access the
> osd if I am fast enough. I also tried vdr-0.98 but the same behavior.
> 
> I don't know what to do now. Any hints?
> 
> :-) Tobias
> 
> P.S.
> Slakware 8.0
> Kernel 2.4.-xfs
> 2 Siemens DVB-S
> 1 encryption module
> LIRC with home brew receiver

This had been discussed up and down, in and out during the past few days.
Apparently Pro-7 has fu**ed up their EPG data (again), which caused the
EIT scanning routines (which relied on correctly set length fields) to crash.

There is a new version of VDR available at

  ftp://ftp.cadsoft.de/pub/people/kls/vdr/vdr-0.99pre4.tgz

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________