[vdr] German Kable Settings

[Nils Pütthoff <np@creators.net>]

Hello All,

did anyone got a complete and up-do-date channel.conf for German
KABLE Settings ?

Thanks Nils

On Sun, Feb 02, 2003 at 09:03:10PM +0100, Henning Holtschneider wrote:
> --On Sonntag, 2. Februar 2003 17:14 +0100 Henning Holtschneider 
> <hh@holtschneider.com> wrote:
> 
> >>- When replaying a recording, VDR very often hangs after FFW 1 minute
> >>with the yellow key. I have to FFW again, than it is OK.
> >
> >I've got serious replay problems with VDR 1.1.20 when a recording is
> >running on the second card (dropouts, a/v out of sync, no fast
> >forward/backward possible). Please see the message "replay hickups when
> >recording on second interface" I wrote to the list last week for details
> >(http://www.linuxtv.org/mailinglists/vdr/2003/01-2003/msg00932.html).
> >
> >With the modified file reader class of the latest VDR 1.1.22, the problem
> >occours less frequently. I'm currently recording a show with VDR 1.1.22
> >so I will see if the problem is gone completely when replaying a file
> >that was recorded with the latest version of VDR.
> 
> I've now tried to replay a recording recorded with VDR 1.1.22 while a timer 
> was active and it worked without distortions! That's the good part ;-)
> 
> However, I'm having serious problems during fast forward/backward or if I 
> use the yellow and green "jump" buttons: during these operations, the 
> picture and sound will freeze most of the time. For example, if I try to 
> jump forward one minute, the playback will freeze and I have to jump back 
> or further forward to resume the replay. Sometimes, even that does not 
> bring back the normal replay and I have to interrupt and restart the 
> replay. This problem is not limited to situations when a recording is 
> running on the second device!
> 
> I think this is some kind of buffer problem. I've got multi-speed replay 
> enabled. If I go into fast forward mode and switch right to step 3, the 
> replay will hang. If I switch to step one, wait 5-10 seconds, then switch 
> to mode 2, wait, switch to mode 3, it works most of the time.
> 
> The machine is a Pentium II running at 300 MHz with a IDE hard drive 
> running on an on-board UDMA-33 controller. The /video partition uses XFS. 
> I've never had these load problems(?) with VDR 1.0.4. Any suggestions?
> 
> Regards,
> hh
> 
> 
> -- 
> Info:
> To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as 
> subject.
---
Nils Puetthoff <np@creators.net>  
http://www.creators.net
ICQ Nr.: 30102529
--


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.