[vdr] Re: vdr-xine-plugin 0.0.2 problem, Micael Beronius

[Onno Kreuzinger <onnok@web.de>]

Hi,

regarding the stutter the author once posted the exact line to edit for a 
large buffer in vdr, thus the plugin will fill up the fifo more, i will 
search for it and post it here.


Regards Onno

Micael Beronius schrieb:
> Thanks,
> This cleanly fixed it!
>
> One thing though, (are you experiencing the same?) after switching channel, I 
> need to hit pause for the fifo to fill up a bit to avoid stutter.
>
> I will do further testing tonight ..
>
>   - Micael
>
> On Friday 14 November 2003 17.18, Jerome Bonnet wrote:
>
> > JB_Sorry, this is my first post to the mailing list, I cannot reply
> > JB_directly to the message.
> > JB_
> > JB_The referred subject was the xine plugin problem reported by Micael
> > JB_Beronius.
> > JB_The plugin do not send any data to xine even if it seems to work
> > JB_properly.
> > JB_The same problem happens with the xineliboutput plugin. This is due to
> > JB_the fact that vdr supports only one primary DVB device (i.e. a device
> > JB_with an mpeg2 decoder). The plugin emulates an mpeg2 decoder board but
> > JB_sends the mpeg2 flux to xine. If you have a full-featured dvb card (with
> > JB_mpeg2 hardware decoding), the flux is sent to this card by default,
> > JB_instead of being sent to the plugin.
> > JB_
> > JB_The solution is to edit the setup.conf and set PrimaryDVB=2 (that is 2
> > JB_if you have one dvb hardware card that takes the first slot).
> > JB_
> > JB_Seems to work now, even if I suffer some segmentation fault when
> > JB_switching channels too often.
> > JB_


--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe vdr" as subject.