I am using vdr 1.3.37 on full featured thechnisat Rev 1.3 card. Drivers
are from kernel 2.6.14.  I have another digital receiver connected
on the loop output of the ss1 board. After closing  vdr by ctrl-c
in console  the ss1  in not powering anymore the LNB 
leaving the other receiver to do that but is not allowing the high
frequency  signal to pass trough (I presume ) since the other
receiver is indicating bad signal. If I restart the computer all is ok
until I start again vdr.  I don't know if the problem is from vdr
or drivers. <br>
<br>
<br>