Selon Lars Bläser <lars.blaeser@lycosxxl.de>:Christian Balzer wrote:second a dum question: where can I change the primary device? I found various discussions about the primary device but i didn't find anything about where to set this. In which configure file is this done???hi, to be certain that the h+ is working you could have a look at the init parameters of the dxr3 drivers, there is a picture generator function intergrated (can´t remember witch module, its to long ago) _______________________________________________ vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdrChristian, A Hollywood+ card needs some specific drivers to be loaded prior to use it ! If your TV is flickering when loading the drivers, it seems that you have some drivers... Meanwhile, the TV screen should normally (often) became grren for a while, before displaying the channel you're watching ! So that, could you please look at the following: 1. If you display loaded modules (bash command is lsmod), do you see the em8300 drivers ? 2. Do you have FFMPEG installed correctly ? EM8300 drivers needs that ! EM8300 is the driver used to manage the Hollywood+ card. More informations about installing/using the DXR3 plugin is located at http://www.linuxtv.org/vdrwiki/index.php/Dxr3-plugin PS: Before changing the setup.conf file for changing the primary device, make sure that vdr is not working ! _______________________________________________ vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr