[linux-dvb] Nebula DigiTV USB Driver

Patrick Boettcher patrick.boettcher at desy.de
Sat May 28 22:54:10 CEST 2005


Hi,

On Sat, 28 May 2005, Michael Hutchinson wrote:

> I have enabled debugging of the dvb-usb module as you suggested but I don't
> see any control transfer dumping. I just see the following in dmesg:
>
> usbcore: registered new driver Nebula Electronics uDigiTV DVB-T USB2.0 device
> usb 1-6: new high speed USB device using ehci_hcd and address 4
> dvb-usb: found a 'Nebula Electronics uDigiTV DVB-T USB2.0)' in cold state,
> will try to load a firmware
> dvb-usb: downloading firmware from file 'dvb-usb-digitv-01.fw' to the 'Cypress
> FX2'
> dvb-usb: Nebula Electronics uDigiTV DVB-T USB2.0) successfully initialized and
> connected.
>
> Does this help?

That's all? There must be something more...

After downloading the firmware to the device, the box should disconnect 
and come back in a new "outfit".

Does this message ("downloading firmware from file ... ") appear several 
times?

Patrick.

--
   Mail: patrick.boettcher at desy.de
   WWW:  http://www.wi-bw.tfh-wildau.de/~pboettch/




More information about the linux-dvb mailing list