[linux-dvb] help with HD5000 (noobe)

[Todd]

I am trying to sort out what is important to worry about and what is not.  I am running:
hd5000-cleanup.patch
Kernel source linux-2.6.13.2
Debian unstable

In my dmesg I am seeing:
w83627hf 2-0290: Invalid sensor type 3; must be 1, 2, or 3435
b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully
flexcop-pci: will use the HW PID filter.
flexcop-pci: card revision 2
ACPI: PCI Interrupt 0000:02:02.0[A] -> GSI 20 (level, low) -> IRQ 23
DVB: registering new adapter (FlexCop Digital TV device).
b2c2-flexcop: MAC address = 00:d0:d7:0e:6c:c0
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
b2c2-flexcop: i2c master_xfer failed
mt352_read_register: readreg error (reg=127, ret==-121)
b2c2-flexcop: i2c master_xfer failed
i2c_readbytes: i2c read error (addr 0a, err == -121)
b2c2-flexcop: found the lgdt3303 at i2c address: 0x59
DVB: registering frontend 0 (LG Electronics LGDT3303 VSB/QAM Frontend)...
b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 3rd generation (HD5000)' at the 'PCI' bus controlled by a 'FlexCopIIb' complete

Are the "i2c master_xfer failed" messages a problem?  If so, what might be causing this?  In mythTV setup when I setup the card as DVB I get "Card Name:  Could not get card info"...and channel scanning is a broken mess.  I am trying to figure out how far back in the error messages to start trying to debug.

(Since I was having other issues with dvd-apps, I am going to the end game: mythTV...maybe a bad idea.)


Huge thanks in advance,
Todd
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.linuxtv.org/pipermail/linux-dvb/attachments/20050927/1497b191/attachment.htm