[linux-dvb] Compro DVB-T200A; Unable to scan
jonas at websystem.se
Tue Aug 8 16:52:38 CEST 2006
> Hi, Jonas
> Jonas Jonsson wrote:
>> I have two Compro DVB-T200A that I can't get to work using Linux. I have
>> verified that the cards works and I can scan using Windows XP.
>> First I load the modules (saa7134 i2c_scan=1, saa7134-dvb, saa7134-alsa)
>> and then I use dvbscan with the correct file for my location. Verified
>> freqs from the brodcasters pages, it's correct and I have manged to tune
>> to that freq using Windows.
>> Here is modprobe, lsmod and dvbscan (The problem)
>> Here is the resulting dmesg
>> I'm running Gentoo with a 184.108.40.206 kernel with some extra patches for
>> Suspend2, I have compiled the v4l-dvb drivers from HG, compiled like an
>> hour ago.
>> Any suggestions, I'm kind of stuck right now.
> Some months ago, i have been in contact with another owner of the 200A.
> problem is that the card identifies itself as a 200, but has very
> hardware. It is a 300, but with the components for analog missing.
> Please try the following:
> In saa7134-dvb.c, from line 353 on, please delete the lines
> /* switch the board to dvb mode */
> init_msg.addr = 0x43;
> init_msg.len = 0x02;
> msg = 0x00;
> msg = 0x40;
> if (fe->ops.i2c_gate_ctrl)
> fe->ops.i2c_gate_ctrl(fe, 1);
> if (i2c_transfer(&dev->i2c_adap, &init_msg, 1) != 1)
> return -EIO;
> Recompile and unload at least the modules saa7134-dvb and saa7134.
> Then reload the driver forcing the card type to 70 (the 300)
> modprobe saa7134 card=70
> modprobe saa7134-dvb
> Now it should work. If it does, please don't forget to report this.
> Afterwards, we need to find a solution we can integrate into mainline.
> Best regards
It works... Thanks, now I can scan...
modprobe saa7134 card=70
I get this in dmesg
saa7130: subsystem: 185b:c901, board: Compro Videomate DVB-T200
More information about the linux-dvb