[linux-dvb] Problem with KNC1 DVB-C card

Vasile Farcas vasilefarcas at yahoo.com
Mon Feb 19 11:23:33 CET 2007

The patch for TDA10023 is working fine, thank you.

Best regards

----- Original Message ----
From: e9hack <e9hack at googlemail.com>
To: linux-dvb at linuxtv.org
Sent: Thursday, February 15, 2007 5:49:50 PM
Subject: Re: [linux-dvb] Problem with KNC1 DVB-C card

Vasile Farcas wrote:
> Hello
> I have a problem with a KNC1 DVB-C card, first was not recognized by the system, and on a lspci -vv reported : 
> 00:0b.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
>         Subsystem: KNC One: Unknown device 0022
>         Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
>         Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
>         Latency: 64 (3750ns min, 9500ns max)
>         Interrupt: pin A routed to IRQ 11
>         Region 0: Memory at fae00000 (32-bit, non-prefetchable) [size=512]
> Then I defined susbsystem 22 in budget-av.c, and the board appeared in /dev/dvb. Unfortunately, the result on scandvb is still the same: 
This is a new card with the TDA10023. You should try the patch from this
mail: http://linuxtv.org/pipermail/linux-dvb/2007-February/015886.html

- Hartmut

linux-dvb mailing list
linux-dvb at linuxtv.org

The fish are biting. 
Get more visitors on your site using Yahoo! Search Marketing.

More information about the linux-dvb mailing list