[linux-dvb] KNC1 DVB-C+, CineView v. 3.0 and Conax CAM: PC card did not respond

Tomas.Linden at Helsinki.FI Tomas.Linden at Helsinki.FI
Thu Feb 22 22:28:36 CET 2007

On Thu, 22 Feb 2007, Jeroen Asselman wrote:

 > Hi.
 > > How can one get debugging information from the CI-module, CAM and the
 > > PC-card to see why the initialization fails?
 > I added the following lines to my modprobe.conf for more debugging info:
 > options dvb-core cam_debug=1,1 debug=1,1
 > options budget-core debug=1,1

I added the following debug options to 
    options dvb-core cam_debug=1,1 debug=1,1
    options budget-core debug=1,1

modprobe budget_av gives then these messages:
saa7146: register extension 'budget_av'.
ACPI: PCI Interrupt 0000:04:08.0[A] -> Link [LNKA] -> GSI 18 (level, low) -> IRQ 21
saa7146: found saa7146 @ mem f8ab4400 (revision 1, irq 21) (0x1894,0x0021).
saa7146 (0): dma buffer size 192512
DVB: registering new adapter (KNC1 DVB-C Plus).
adapter failed MAC signature check
encoded MAC from EEPROM was ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff
budget_av: saa7113_init(): saa7113 detected and initializing
budget_av: saa7113_init(): saa7113  status=d0
saa7146_vv: saa7146 (0): registered device video1 [v4l2]
KNC1-0: MAC addr = 00:09:d6:6d:5c:c4
DVB: registering frontend 0 (Philips TDA10021 DVB-C)...
budget-av: ci interface initialised.

Inserting the Conax CAM with the Conax card gives these messages:
budget-av: cam inserted B
budget_av: ciintf_slot_reset(): ciintf_slot_reset
dvb_ca adaptor 0: PC card did not respond :(

Removing it gives these messages:
budget_av: ciintf_slot_shutdown(): ciintf_slot_shutdown
budget-av: cam ejected 5
budget_av: ciintf_slot_shutdown(): ciintf_slot_shutdown
Slot 0 shutdown

rmmod budget_av gives this message:
ACPI: PCI interrupt for device 0000:04:08.0 disabled

What can be learned from this?

Best regards,                           Tomas Lindén

More information about the linux-dvb mailing list