[linux-dvb] ooops ! New DiB0700-firmware
nico at youplala.net
Mon Jul 30 23:10:00 CEST 2007
On Mon, 2007-07-30 at 22:55 +0200, Janne Grunau wrote:
> You need a cold (powerless) reboot to get the new firmware loaded.
> don't have to worry about the firmware file. The exact filename is
> hardcoded in the source.
> You can check if you look in your kernel messages for following line:
> dvb-usb: downloading firmware from file 'dvb-usb-dib0700-03-pre1.fw'
[ 30.965645] dib0700: loaded with support for 5 different device-types
[ 30.965925] dvb-usb: found a 'Hauppauge Nova-T 500 Dual DVB-T' in cold state, will try to load a firmware
[ 31.008899] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-03-pre1.fw'
[ 31.015377] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level, low) -> IRQ 22
[ 31.016189] PCI: Setting latency timer of device 0000:00:1b.0 to 64
[ 31.206081] dib0700: firmware started successfully.
[ 31.265279] NET: Registered protocol family 17
[ 31.711176] dvb-usb: found a 'Hauppauge Nova-T 500 Dual DVB-T' in warm state.
[ 31.711222] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 31.711325] DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T)
[ 31.831535] DVB: registering frontend 0 (DiBcom 3000MC/P)...
[ 31.854890] MT2060: successfully identified (IF1 = 1220)
[ 32.388673] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[ 32.388853] DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T)
[ 32.394293] DVB: registering frontend 1 (DiBcom 3000MC/P)...
[ 32.398790] MT2060: successfully identified (IF1 = 1220)
[ 32.959607] input: IR-receiver inside an USB DVB receiver as /class/input/input4
[ 32.959633] dvb-usb: schedule remote query interval to 150 msecs.
[ 32.959637] dvb-usb: Hauppauge Nova-T 500 Dual DVB-T successfully initialized and connected.
[ 32.959657] usbcore: registered new interface driver dvb_usb_dib0700
More information about the linux-dvb