[linux-dvb] No frontend attached by 'Hauppauge Nova-T Stick'

MacJariel macjariel at gmail.com
Thu May 3 17:03:56 CEST 2007


Hi,
I've just bought Hauppauge Nova-T Stick. I tried to make it work under
kernel 2.6.19 and I managed - everything seemed to be alright. But
some minutes later it stopped working.

I'm loading the modules with debug=1 option and this is my output from dmesg:

usb 1-5: new high speed USB device using ehci_hcd and address 7
usb 1-5: configuration #1 chosen from 1 choice
check for cold 10b8 1e14
check for cold 10b8 1e78
check for cold 2040 7050
check for cold 2040 7060
FW GET_VERSION length: -32
cold: 1
dvb-usb: found a 'Hauppauge Nova-T Stick' in cold state, will try to
load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw'
dib0700: firmware started successfully.
dvb-usb: found a 'Hauppauge Nova-T Stick' in warm state.
power control: 1
i2c_adapter i2c-3: adapter [Hauppauge Nova-T Stick] registered
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
DVB: registering new adapter (Hauppauge Nova-T Stick).
i2c_adapter i2c-3: master_xfer[0] W, addr=0x09, len=2
i2c_adapter i2c-3: master_xfer[1] R, addr=0x09, len=2
I2C read failed on address 9
i2c_adapter i2c-3: master_xfer[0] W, addr=0x40, len=2
i2c_adapter i2c-3: master_xfer[1] R, addr=0x40, len=2
I2C read failed on address 40
DiB7000P:-D-  DiB7000PC not detected
i2c_adapter i2c-3: master_xfer[0] W, addr=0x09, len=2
i2c_adapter i2c-3: master_xfer[1] R, addr=0x09, len=2
I2C read failed on address 9
DiB7000M:i2c read error on 896
DiB7000M:-E-  DiB7000M: wrong Vendor ID (read=0x80e7)
dvb-usb: no frontend was attached by 'Hauppauge Nova-T Stick'
power control: 0
dvb-usb: Hauppauge Nova-T Stick successfully initialized and connected.

I found similar problem in linux-dvb archives but it didn't help me anyway.
Thanks for reply,

MacJariel



More information about the linux-dvb mailing list