[linux-dvb] [PATCH] scan-s2: fixes and diseqc rotor support
alex.betis at gmail.com
Wed Nov 12 11:43:23 CET 2008
On Wed, Nov 12, 2008 at 4:31 AM, Hans Werner <HWerner4 at gmx.de> wrote:
> I have attached two patches for scan-s2 at
> Patch1: Some fixes for problems I found. QAM_AUTO is not supported by all
> in particular the HVR-4000, so one needs to use QPSK as the default and
> ensure that
> settings are parsed properly from the network information -- the new S2
> FECs and
> modulations were not handled.
> Patch2: Add DiSEqC 1.2 rotor support. Use it like this to move the dish to
> the correct
> position for the scan:
> scan-s2 -r 19.2E -n dvb-s/Astra-19.2E
> scan-s2 -R 2 -n dvb-s/Astra-19.2E
> A file (rotor.conf) listing the rotor positions is used (NB: rotors vary --
> do check your
> rotor manual).
I didn't check the diff files yet, will do it when I get home.
But I don't think QPSK should be used by default. I have a version already
where you can specify which scan mode you want to be performed DVB-S or
DVB-S2 by specifying S1 or S2 in freq file, also if you implicitly specify
QPSK in frequency file the utility will not scan DVB-S2, same logic also for
8PSK that will scan only DVB-S2 and will not try to scan DVB-S.
I'll push that version soon to the repository.
The default should stay the AUTO mode since there are cards that can handle
that and their owners might have simplified frequency file version.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the linux-dvb