[linux-dvb] Asus MyCinema P7131 Dual support
hermann-pitton at arcor.de
Wed Sep 22 01:13:00 CEST 2010
Am Dienstag, den 21.09.2010, 10:07 +0200 schrieb Dejan Rodiger:
> I am using Ubuntu linux 10.10 with the latest kernel 2.6.35-22-generic
> on x86_64. I have installed nonfree firmware which should support this
> card, but to be sure, can somebody confirm that my TV card is
> supported in Analog or DVB mode?
> sudo lspci -vnn
> 01:06.0 Multimedia controller : Philips Semiconductors
> SAA7131/SAA7133/SAA7135 Video Broadcast Decoder [1131:7133] (rev d1)
> Subsystem: ASUSTeK Computer Inc. My Cinema-P7131 Hybrid
> Flags: bus master, medium devsel, latency 32, IRQ 18
> Memory at fdeff000 (32-bit, non-prefetchable) [size=2K]
> Capabilities:  Power Management version 2
> Kernel driver in use: saa7134
> Kernel modules: saa7134
> It says Hybrid, but I put the following in
> the /etc/modprobe.d/saa7134.conf
> options saa7134 card=78 tuner=54
> Dejan Rodiger
> S: callto://drodiger
don't have time to follow this closely anymore.
But forcing it to card=78 is plain wrong. It has an early additional LNA
in confirmed config = 2 status.
Your card should be auto detected and previously always was, based on
what we have in saa7134-cards.c and further for it. (saa7134-dvb and
related tuner/demod stuff)
.vendor = PCI_VENDOR_ID_PHILIPS,
.device = PCI_DEVICE_ID_PHILIPS_SAA7133,
.subvendor = 0x1043,
.subdevice = 0x4876,
.driver_data = SAA7134_BOARD_ASUSTeK_P7131_HYBRID_LNA,
I remember for sure, that this card was fully functional for all use
cases and it was not easy to get it there. I don't have it.
Please provide the "dmesg" for failing auto detection without forcing
some card = number as a starting point.
I for sure want to see this board fully functional again.
More information about the linux-dvb