Compro Videomate C200: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
(5 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
I'M WORKING ON THIS PAGE... INFORMATION IS NOT OK |
|||
[[Image:compro-videomate-c200-usb-low.jpg|right|thumb|200px|C200 USB Stick]] |
[[Image:compro-videomate-c200-usb-low.jpg|right|thumb|200px|C200 USB Stick]] |
||
Line 24: | Line 22: | ||
HKR,,PageOutWhenUnopened,3,01 |
HKR,,PageOutWhenUnopened,3,01 |
||
HKR,,DontSuspendIfStreamsAreRunning,3,01 |
HKR,,DontSuspendIfStreamsAreRunning,3,01 |
||
;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},,,"Analog Copy Protection Notifier" |
;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},,,"Analog Copy Protection Notifier" |
||
;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},IID,1,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00 |
;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},IID,1,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00 |
||
HKLM,Software\Tridvid\Tuner,Name,0,"LG Z200T" |
HKLM,Software\Tridvid\Tuner,Name,0,"LG Z200T" |
||
HKLM,Software\Tridvid\Tuner,Type,0x00010001,0 |
HKLM,Software\Tridvid\Tuner,Type,0x00010001,0 |
||
HKLM,Software\Tridvid\IRDecoderType,Name,0,"NEC Decoder" |
HKLM,Software\Tridvid\IRDecoderType,Name,0,"NEC Decoder" |
||
HKLM,Software\Tridvid\IRDecoderType,Type,0x00010001,0 |
HKLM,Software\Tridvid\IRDecoderType,Type,0x00010001,0 |
||
===Identification=== |
===Identification=== |
||
# lsusb -v |
|||
# lspci -vvvnn |
|||
Bus 001 Device 009: ID 185b:0200 Compro |
|||
04:03.0 Multimedia controller [0480]: Philips Semiconductors SAA7130 Video Broadcast Decoder [1131:7130] (rev 01) |
|||
Device Descriptor: |
|||
Subsystem: Compro Technology, Inc. Videomate DVB-T200 [185b:c901] |
|||
bLength 18 |
|||
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- |
|||
bDescriptorType 1 |
|||
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- |
|||
bcdUSB 2.00 |
|||
Latency: 84 (21000ns min, 8000ns max) |
|||
bDeviceClass 0 (Defined at Interface level) |
|||
Interrupt: pin A routed to IRQ 20 |
|||
bDeviceSubClass 0 |
|||
Region 0: Memory at fdcfe000 (32-bit, non-prefetchable) [size=1K] |
|||
bDeviceProtocol 0 |
|||
Capabilities: [40] Power Management version 1 |
|||
bMaxPacketSize0 64 |
|||
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) |
|||
idVendor 0x185b Compro |
|||
Status: D0 PME-Enable- DSel=0 DScale=1 PME- |
|||
idProduct 0x0200 |
|||
bcdDevice 0.01 |
|||
iManufacturer 16 Compro |
|||
iProduct 32 VM C200 |
|||
iSerial 64 � |
|||
bNumConfigurations 1 |
|||
==Making it Work== |
==Making it Work== |
||
''Not working in Linux'' |
|||
''Is it supported under Linux? Are there experimental drivers? Does it partially work or identify as another card? (if yes, add this information below)'' |
|||
===Firmware=== |
|||
''Is there any firmware specific information for this device? if so, list it here. If your device doesn't require a firmware, simply mention that this is the case.'' |
|||
===Drivers=== |
|||
''Provide the details of where the drivers and patches and necessary tools are available.'' |
|||
===Sample Kernel Output=== |
===Sample Kernel Output=== |
||
dmesg doesn't show any new line with <code>dmesg | tail -f</code> when the device is plugged. |
|||
''Provide the '''relevant''' portion of dmesg here. For example:''<br> |
|||
# dmesg |
|||
[ 45.569669] saa7130/34: v4l2 driver version 0.2.14 loaded |
|||
[ 45.569739] saa7130[0]: found at 0000:04:03.0, rev: 1, irq: 20, latency: 84, mmio: 0xfdcfe000 |
|||
[ 45.569745] saa7130[0]: subsystem: 185b:c901, board: Compro Videomate DVB-T200 [card=71,autodetected] |
|||
[ 45.569753] saa7130[0]: board init: gpio is 843f00 |
|||
[ 45.569809] input: saa7134 IR (Compro Videomate DV as /devices/pci0000:00/0000:00:1e.0/0000:04:03.0/input/input7 |
|||
[ 45.755429] saa7130[0]: i2c eeprom 00: 5b 18 01 c9 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 |
|||
[ 45.755437] saa7130[0]: i2c eeprom 10: 00 ff 86 0f ff 20 ff ff ff ff ff ff ff ff ff ff |
|||
[ 45.755443] saa7130[0]: i2c eeprom 20: 01 40 01 03 03 ff 03 01 08 ff 00 88 ff ff ff ff |
|||
[ 45.755449] saa7130[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff |
|||
[ 45.755454] saa7130[0]: i2c eeprom 40: ff d5 00 c4 86 1e ff ff ff ff ff ff ff ff ff ff |
|||
[ 45.755460] saa7130[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff cb |
|||
[ 45.755466] saa7130[0]: i2c eeprom 60: 30 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff |
|||
[ 45.755471] saa7130[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff |
|||
[ 45.755478] saa7130[0]: Unexpected tuner type info: d5 in eeprom |
|||
[ 45.755532] saa7130[0]: registered device video0 [v4l2] |
|||
[ 45.755550] saa7130[0]: registered device vbi0 |
|||
[ 45.873425] saa7134 ALSA driver for DMA sound loaded |
|||
[ 45.873448] saa7130[0]/alsa: saa7130[0] at 0xfdcfe000 irq 20 registered as card -2 |
|||
[ 45.943354] saa7130[0]/dvb: frontend initialization failed |
|||
===Remote Control Support=== |
|||
''Discuss support for the remote control here.'' |
|||
==External Links== |
==External Links== |
||
⚫ | |||
''Provide a link to the vendor's product page here along with any other external link to information that is generally helpful in relation to the device. For example:''<br> |
|||
⚫ | |||
''Finally, add anything else that you think might be relevant under an appropriate heading.'' |
|||
''Very last thing is add a catergory. (Remove the nowiki tags). For example''<br> |
|||
<nowiki>[[Category:DVB-T PCI Devices]]</nowiki> |
Latest revision as of 18:46, 7 November 2009
An analog acquisition usb stick from Compro
No Linux support right now (07/11/2009)
Overview/Features
Features :
- Outputs : USB interface, nice for laptops
- Inputs: S-Video and RCA
- Software : Only XP and Vista only and very heavy Ulead software which doesn't run on Virtualbox (brrr)
Components Used
List the hardware modules used by the device:
- Trident USB 2.0 Video Processors
Win Driver sample
[c200Vid.AddReg.NTamd64] HKR,,DevLoader,,*ntkern HKR,,NTMPDriver,,U2800Vid64.sys HKR,,PageOutWhenUnopened,3,01 HKR,,DontSuspendIfStreamsAreRunning,3,01 ;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},,,"Analog Copy Protection Notifier" ;HKLM,%MediaInterfaces%\{E65084D3-29F6-4ac6-9CD3-2B2D58FF6403},IID,1,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00,00 HKLM,Software\Tridvid\Tuner,Name,0,"LG Z200T" HKLM,Software\Tridvid\Tuner,Type,0x00010001,0 HKLM,Software\Tridvid\IRDecoderType,Name,0,"NEC Decoder" HKLM,Software\Tridvid\IRDecoderType,Type,0x00010001,0
Identification
# lsusb -v Bus 001 Device 009: ID 185b:0200 Compro Device Descriptor: bLength 18 bDescriptorType 1 bcdUSB 2.00 bDeviceClass 0 (Defined at Interface level) bDeviceSubClass 0 bDeviceProtocol 0 bMaxPacketSize0 64 idVendor 0x185b Compro idProduct 0x0200 bcdDevice 0.01 iManufacturer 16 Compro iProduct 32 VM C200 iSerial 64 � bNumConfigurations 1
Making it Work
Not working in Linux
Sample Kernel Output
dmesg doesn't show any new line with dmesg | tail -f
when the device is plugged.