Fitipower

Tuner used together with AF9035.

Specifications

Don't trust this blindly.

Tuner general info

I2C address is 0xC0. There are 18 tuner registers indexed from 0. Always integer division.

Index	Name
1	FA
2	FP
3,4	XIN
5	VCO
6	VCO_SELECT
14	VCO_CALIBRATE

Init/Reset

Enable tuner:

• write 1 to GPIO 0xD8EB
• write 1 to GPIO 0xD8EC
• write 1 to GPIO 0xD8ED

Enable led:

• write 1 to GPIO 0xD8D1
• write 1 to GPIO 0xD8D0

UnInit

Disable led:

• write 0 to GPIO 0xD8D1
• write 0 to GPIO 0xD8D0

Tune

Tuning is based on 2 parameters:

• bandwidth in Hz, can be 6000,7000 or 8000
• frequency in Hz, can be the regular DVB-T frequency's

Init tuning

• write 0x0F to tuner register 7
• write 0x3E to tuner register 8
• write 0xB8 to tuner register 10
• write 0x80 to tuner register 11
• write 0x04 to tuner register 13

Generate the frequency of VCO and the VCO divider

fvco is a parameter

if frequency < 54000

• set fvco to frequency * 64
• set tuner registry 5 to 0x82

if 54000 =< frequency < 108000

• set fvco to frequency * 32
• set tuner registry 5 to 0x42

if 108000=< frequency < 216000

• set fvco to frequency * 16
• set tuner registry 5 to 0x22

if 216000=< frequency < 432000

• set fvco to frequency * 8
• set tuner registry 5 to 0x12

if frequency > 432000

• set fvco to frequency * 4
• set tuner registry 5 to 0x0A

Calculate XIN

fraction is a 16bit unsigned parameter, xin is a parameter, fvco is a pre-calculated parameter, xdiv is a parameter

• set xdiv equal to floor(fvco/18000)
• set fraction equal to fvco minus xdiv multiplied by 18000
• set fraction equal to fraction left shifted 15 times and then divided by 18000
• if fraction is greater or equal to 16384
  • set fractional equal to fractional plus 32768
• if fraction is equal to 0
  • set xin equal to 0
• if 0 < fraction < 511
  • set xin equal to 0x200
• if 511 < fraction <= 65025
  • set xin equal to fraction
• if 65025 < fraction
  • set xin equal to 0xfe00
• write xin right shifted 8 times to tuner register 3
• write xin only 8 low bits to tuner register 4

Calculate FP and FA

TBD

Select bandwidth

• if bandwidth = 8000
  • set tuner registry 6 to 0x0

• if bandwidth = 7000
  • set tuner registry 6 to 0x40

• if bandwidth = 6000
  • set tuner registry 6 to 0x80

Fix for low frequency's

if frequency < 45000

• set tuner registry 1 to 0x06
• set tuner registry 2 to 0x11

Fix clock out

• set tuner registry 6 to the result of a bitwise OR between tuner registry 6 and 0x20

Write frequency parameters

• write tuner registry 0-6