Archived:Pinnacle PCTV Pro (first draft): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
m (Fix double redirect.) |
||
| (6 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
#REDIRECT [[Pinnacle PCTV Pro]] |
|||
See |
|||
*[[Cardlist.BTTV]] |
|||
*[[Bttv devices (bt848, bt878)]] |
|||
==Remote controllers== |
|||
[[Image:Pinnacle 50or110 i remote.jpg]] |
|||
The cards are supplied with the controller to the right, which is the same as for [[Pinnacle PCTV 50i]] |
|||
==Card features== |
|||
* PCI |
|||
* Video/audio decoder: [[Bt848]] |
|||
* Analog demodulator: TBD |
|||
* TV tuner: Temic 3X7 756 |
|||
==Card connectors== |
|||
* TV RF signal: ??? with adapter to IEC connector (PAL) |
|||
* Video Input: S-Video |
|||
* Video Input: Composite Video (RCA socket) |
|||
* Audio Outputs: 3.5 mm jack |
|||
* FM radio RF signal: Internal RC jack with flying wire to IEC connector |
|||
The IR-Remote requires a 9 pin serial connector |
|||
==lspci -v== |
|||
00:0a.0 Multimedia video controller: Brooktree Corporation Bt848 Video Capture (rev 12) |
|||
Flags: bus master, medium devsel, latency 32, IRQ 21 |
|||
Memory at e2001000 (32-bit, prefetchable) [size=4K] |
|||
==Module Options== |
|||
the card is autodetected |
|||
==Kernel output== |
|||
bttv: driver version 0.9.16 loaded |
|||
bttv: using 8 buffers with 2080k (520 pages) each for capture |
|||
bttv: Bt8xx card found (0). |
|||
ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 21 |
|||
bttv0: Bt848 (rev 18) at 0000:00:0a.0, irq: 21, latency: 32, mmio: 0xe2001000 |
|||
bttv0: using: *** UNKNOWN/GENERIC *** [card=0,autodetected] |
|||
bttv0: gpio: en=00000000, out=00000000 in=00e707df [init] |
|||
tuner 2-0060: All bytes are equal. It is not a TEA5767 |
|||
tuner 2-0060: chip found @ 0xc0 (bt848 #0 [sw]) |
|||
tuner 2-0061: chip found @ 0xc2 (bt848 #0 [sw]) |
|||
tveeprom 2-0050: Huh, no eeprom present (err=-121)? |
|||
bttv0: using tuner=-1 |
|||
bttv0: i2c: checking for MSP34xx @ 0x80... found |
|||
msp3400 2-0040: MSP3410D-B4 found @ 0x80 (bt848 #0 [sw]) |
|||
msp3400 2-0040: MSP3410D-B4 supports nicam, mode is autodetect |
|||
bttv0: i2c: checking for TDA9875 @ 0xb0... not found |
|||
bttv0: i2c: checking for TDA7432 @ 0x8a... not found |
|||
bttv0: i2c: checking for TDA9887 @ 0x86... not found |
|||
bttv0: registered device video1 |
|||
bttv0: registered device vbi1 |
|||
tuner 2-0060: tuner type not set |
|||
==Note== |
|||
==Links== |
|||
Latest revision as of 07:52, 18 December 2016
Redirect to: