Archived:Pinnacle PCTV Pro (first draft)
Jump to navigation
Jump to search
These Pinnacle cards are based on the Bt848 chip.
See
Remote controllers
The cards are supplied with the controller to the right, which is the same as for Pinnacle PCTV 50i
Card features
- PCI
- Video/audio decoder: Bt848
- Analog demodulator: TBD
- TV tuner: Temic 3X7 756
Card connectors
- TV RF signal: ??? with adapter to IEC connector (PAL)
- Video Input: S-Video
- Video Input: Composite Video (RCA socket)
- Audio Outputs: 3.5 mm jack
- FM radio RF signal: Internal RC jack with flying wire to IEC connector
The IR-Remote requires a 9 pin serial connector
lspci -v
00:0a.0 Multimedia video controller: Brooktree Corporation Bt848 Video Capture (rev 12)
Flags: bus master, medium devsel, latency 32, IRQ 21
Memory at e2001000 (32-bit, prefetchable) [size=4K]
Module Options
the card is autodetected
Kernel output
bttv: driver version 0.9.16 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 21 bttv0: Bt848 (rev 18) at 0000:00:0a.0, irq: 21, latency: 32, mmio: 0xe2001000 bttv0: using: *** UNKNOWN/GENERIC *** [card=0,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00e707df [init] tuner 2-0060: All bytes are equal. It is not a TEA5767 tuner 2-0060: chip found @ 0xc0 (bt848 #0 [sw]) tuner 2-0061: chip found @ 0xc2 (bt848 #0 [sw]) tveeprom 2-0050: Huh, no eeprom present (err=-121)? bttv0: using tuner=-1 bttv0: i2c: checking for MSP34xx @ 0x80... found msp3400 2-0040: MSP3410D-B4 found @ 0x80 (bt848 #0 [sw]) msp3400 2-0040: MSP3410D-B4 supports nicam, mode is autodetect bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found bttv0: i2c: checking for TDA9887 @ 0x86... not found bttv0: registered device video1 bttv0: registered device vbi1 tuner 2-0060: tuner type not set