Re: Routing Probs with dvb0

[Robin Edgar Tripany <red@tripany.com>]

K...... got dvbd drivers compiled, installed and they work :)

got dvbd compiled and dvbd.conf editted to my specific settings....
my primary questions are:

1. When i run dvbd without the -q option i get these lines over and over
again:

    "VFsync = 0, Freq = 2033000000, Sync = 3 Afc = 4293076671 Agc = 319 Nest
= 43264"
    "VFsync = 0, Freq = 2033000000, Sync = 3 Afc = 4293076671 Agc = 303 Nest
= 43776"

    is this ok?
2. How many filters do i need in /etc/dvbd.conf?
    (under windows i have 5!!!!)
3. how do you set a MAC address on your card?
4. as i understand you have to use mrouted to multicast your streams,
    what are the tunnel settings? (local ip = my uplink device? remote=???)
    might you have your mrouted.conf file?
     I dont really understand the mrouted.conf file :)))

    "phyint dvb0 altnet 212.17.1.212/1 altnet 125.0.0.0/1"
    "phyint eth0"

    is the first altnet my ppp device and the second one the destination
address?

well, i hope someone can help me :)

thanx

robin


----- Original Message -----
From: "Uwe Guenther" <uwe@cscc.de>
To: "Robin Edgar Tripany" <red@tripany.com>
Sent: Thursday, October 05, 2000 5:28 PM
Subject: Re: Routing Probs with dvb0


> Robin Edgar Tripany wrote:
> >
> > What did you use to get EON working?! where can i find the sources?
> >
>
> http://www.linuxtv.org/download/dvb/siemens_dvb-0.7.1.tar.gz
> http://www.linuxtv.org/download/dvb/dvbd2.tar.gz
>
>  and you could check my config, they is located at
>
> http://www.cscc.de/eon.tar.gz
>
>
> ... may the Tux be with you! =Uwe=
> --
> Uwe Günther                    \\://                  mailto:uwe@cscc.de
> Haupstraße 88                  (o -)                  http://www.cscc.de
> 98631 Behrungen          ---ooO-(_)-Ooo---          tel.:+49.36944.54448
> Germany                                       Linux, enjoy the ride ...!
>