Mailing List archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[linux-dvb] Re: Segmentation fault in DTV1.1.2
Jean-Claude REPETTO schrieb:
>
> I have installed DTV 1.1.2 and I have made these settings in the file
> dtv.conf :
>
> set outdev0 [open_output DVBS 0]
> source available_channels.dcl
> source channel_list.dcl
> add_channel_list -all $channel_list
>
> set indev1 [open_input LIRCD]
> set lircd_table_0 {
> { {UP} "+" } { {DOWN} "-" } { {a} "a" }
> { {Ok} "o" } { {b} "r" } { {c} "g" }
> { {d} "y" } { {e} "b" } { {0} "0" }
> { {1} "1" } { {2} "2" } { {3} "3" }
> { {4} "4" } { {5} "5" } { {6} "6" }
> { {7} "7" } { {8} "8" } { {9} "9" }
> }
> add_implication $outdev0 $indev1 $lircd_table_0
> set_osd_language -all ENGLISH
>
> Then I have installed the DVB driver (make insmod), and launched lircd with
> the correct remote control configuration file.
>
> Then I have launched DTV, but as soon as I press a key on the remote
> control, it stops immediately with the message "Segmentation fault".
>
> Do you see anything wrong in my conf file ?
>
Yes I do, the name of the remote control (from LIRCD) is missing...should be:
set lircd_table_0 {
{ {UP <name>} "+" } { {DOWN <name>} "-" } { {a <name>} "a" }
{ {Ok <name>} "o" } { {b <name>} "r" } { {c <name>} "g" }
{ {d <name>} "y" } { {e <name>} "b" } { {0 <name>} "0" }
{ {1 <name>} "1" } { {2 <name>} "2" } { {3 <name>} "3" }
{ {4 <name>} "4" } { {5 <name>} "5" } { {6 <name>} "6" }
{ {7 <name>} "7" } { {8 <name>} "8" } { {9 <name>} "9" }
}
But that should definitely not lead to a segfault...I will have a look at
that...
Regards,
Rolf
--
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.
Home |
Main Index |
Thread Index