[linux-dvb] Re: Transponder switching taking considerably longer

[Oliver Endriss <o.endriss@gmx.de>]

On Friday 25 July 2003 17:32, Klaus Schmidinger wrote:
> Oliver Endriss wrote:
> > On Friday 25 July 2003 16:44, Klaus Schmidinger wrote:
> > > Oliver Endriss wrote:
> > > > ...I recently changed I2C bus speed from 10.3kHz to 275kHz to
> > > > speed up tuning and I2C firmware downloads. At least it does
> > > > for me. ;-)
> > > >
> > > > Maybe this causes problems with some frontends if they need
> > > > some delays between tuning and status check. Or they cannot
> > > > handle the high speed reliably...
> > > >
> > > > Try to change
> > > >     SAA7146_I2C_BUS_BIT_RATE_120
> > > > back to
> > > >     SAA7146_I2C_BUS_BIT_RATE_3200
> > > > in saa7146_core.c. Does it make a difference?
> > >
> > > This results in
> > >
> > > Jul 25 16:41:44 video kernel: DVB: AV7111(0) - firm f0240009,
> > > rtsl b0250018, vid 71010068, app 8000261a Jul 25 16:41:44 video
> > > kernel: DVB: AV7111(0) - firmware supports CI link layer
> > > interface Jul 25 16:41:45 video kernel: av7110(0): adac type set
> > > to 0
> > > Jul 25 16:41:45 video kernel: Couldn't read from EEPROM: not
> > > there? ...
> > > and the screen stays black (the OSD works, though).
> >
> > Argh, I think you have to increase the udelay(20) in saa7146.c line
> > 1286 for the lower speed. Try something like udelay(500).
>
> With this change (in addition to the one you suggested first) it
> works as fast as before (at least as far as I can tell, but the
> difference was pretty obvious).

I hoped this would not happen. ;-)
Hm, could you try to increase the speed again but set the delay to 500us 
or 1000us. I'd like to know whether it is a matter of bus speed or a 
timing issue. I think that timing problems should be fixed in the 
frontend driver. If nothing else helps we have to revert my change.

Oliver



-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.