[linux-dvb] Re: Missing Subsystem

[Hans-Peter Raschke <Hans-Peter.Raschke@Wintermann-DatenService.de>]

Ralph Metzler schrieb:
> Oliver Endriss writes:
>  > On Friday 26 September 2003 14:52, Bruno Hellstern wrote:
>  > > ...
>  > > here ist the output of both cards, 1st without subsystem:
>  > > 
>  > > 00:0d.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
>  > >         Flags: bus master, medium devsel, latency 64, IRQ 10
>  > >         Memory at ff000800 (32-bit, non-prefetchable) [size=512]
>  > > 00: 31 11 46 71 06 00 80 02 01 00 80 04 00 40 00 00
>  > > 10: 00 08 00 ff 00 00 00 00 00 00 00 00 00 00 00 00
>  > > 20: 00 00 00 00 00 00 00 00 00 00 00 00 ff ff ff ff
>  >                                           ^^^^^^^^^^^
>  > > 30: 00 00 00 00 00 00 00 00 00 00 00 00 0a 01 ff ff
>  > 
>  > This card has an invalid sub-vendor/device id. :-(
>  > Obviously the eeprom of the card is broken or has been overwritten.
>  > 
>  > As a workaround you can add the line
>  >   { PHILIPS_SAA7146, 0xffff, 0xffff, CARD_INFO fs_1_3 },
>  > to the table at the end of saa7146_core.c
>
>
> If the EEPROM is still writable you could also try to write the
> correct values.
> The 0.7.x bttv driver dist contains a tool to read/write EEPROMs via
> i2c-dev if your driver supports it.
>
>
> Ralph
setpci did the job for me.

Hans-Peter



--
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.