[vdr] Re: Got Xine-lib, Xine-ui to compile... but...

[Norm Dressler <norm@dressler.ca>]

1.3.12 did the trick... I have xine working now.  

Now I need to get Softdevice working....


On October 8, 2004 07:52 am, Norm Dressler wrote:
> I was running vdr from the command line and it says the vdr-xine:
> client-connecting...  which I had when this config was working before so
> this looks normal.
>
> I fire xine up from the command line with the verbose option below and with
> the MRL to the vdr stream and this is the output:
>
> xine: found demuxer plugin: Elementary MPEG stream demux plugin
> video discontinuity #1, type is 0, disc_off 0
> waiting for audio discontinuity #1
> audio discontinuity #1, type is 0, disc_off 0
> waiting for in_discontinuity update #1
> vpts adjusted with prebuffer to 21551
> load_plugins: plugin dxr3-mpeg2 failed to instantiate itself.
> load_plugins: plugin mpeg2 will be used for video streamtype 00.
> gui_xine_open_and_play():
>         mrl: 'vdr://tmp/vdr-xine/stream#demux:mpeg_pes',
>         sub 'NONE',
>         start_pos 0, start_time 0, av_offset 0, spu_offset 0.
> xine: found input plugin  : VDR display device plugin
> read(): Success.
> xine: found demuxer plugin: mpeg pes demux plugin
> video discontinuity #2, type is 0, disc_off 0
> waiting for audio discontinuity #2
> audio discontinuity #2, type is 0, disc_off 0
> waiting for in_discontinuity update #2
> vpts adjusted with prebuffer to 28677
> av_offset=0 pts
> spu_offset=0 pts
> xine_play
> __play_internal ...done
>
> The problem is that I don't get any video or audio and I don't get any
> menus -- VDR seems frozen because I can't even change channels up and down
> like I used to with the arrow keys (I can when xine isn't running).  So not
> sure what is happening.  I removed and recompiled everything just to be
> sure -- checking all of my drive mappings and still same thing.  I'm
> running VDR 1.3.11 and one of my other questions was about softdevice and
> it suggests 1.3.12 so I will give it a shot.
>
> Norm
>
> On October 8, 2004 02:00 am, Jouni Karvo wrote:
> > hello,
> >
> >  > Any suggestions what might be wrong?
> >
> > check vdr output (you can run vdr directly from command line), and try
> > running xine with --verbose=2
> >
> > Have you checked that the paths defined in vdr-xine plugin's Makefile
> > are correct for your setup?
> >
> > yours,
> >   Jouni