spi_register_board_info — register SPI devices for a given board
int spi_register_board_info ( | struct spi_board_info const * info, |
unsigned n); |
Board-specific early init code calls this (probably during arch_initcall) with segments of the SPI device table. Any device nodes are created later, after the relevant parent SPI controller (bus_num) is defined. We keep this table of devices forever, so that reloading a controller driver will not make Linux forget about these hard-wired devices.
Other code can also call this, e.g. a particular add-on board might provide SPI devices through its expansion connector, so code initializing that board would naturally declare its SPI devices.
The board info passed can safely be __initdata ... but be careful of any embedded pointers (platform_data, etc), they're copied as-is.