[linux-dvb] AW: Re: Remote controls at Rev. 1.3

["Jochen Vieten" <J.Vieten@digital-device.de>]

hi list,

Joerg Riechardt wrote:
> How to install the remote control at Rev.1.3.
> 1. in lirc 0.6.5pre1 configure point 1 Driver there is already under point
4 TV Cards the
> Hauppauge DVBs Card,
> there is only ver 2.1 mentioned, but rev 1.3 works as well.
> save + run, make, make install
> 2. in DVB/driver/lirc/Makefile adapt path for lirc location
> make
> 3. lircd.conf has to be adapted, bits 13 -> 32,
> code 000000000000yyxx -> 00000000800000xx, see
http://www.uni-mainz.de/~martin/lircd.conf
> 4. DVB/driver make insmod, insmod lirc_dev, insmod lirc_dvb, lircd
> Even the original Hauppauge remote works! I suspected it not to work,
because I get no
> ircommands in syslog from it, and I  don't understand, how it can work
without producing them.

> Jörg

i start lircd and get this output:

lircd(hauppauge) ready

if i start vdr or irw, lircd quits:

accepted new client on /dev/lircd
could not get hardware features
this device driver does not support the new LIRC interface
make sure you use a current version of the driver
caught signal
Terminated

Any hints? (Suse Linux 7.2, Lirc 0.6.4, 2xHauppauge DVB-S Rev. 2.1,
DVB-driver 30112001, VDR 0.98...)

Thanx,

Jochen Vieten



-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe linux-dvb" as subject.