[linux-dvb] Re: Add Vendor ID/Device ID for TechnoTrend DVB-T Card

[Oliver Endriss <o.endriss@gmx.de>]

Paolo Casagranda wrote:
>
> [card with vendor/device 0xA000/0xA000]
>
I think Robert is right. These ids don't make any sense.
Either your card is defective or your system is unable to read the 
config eeprom. Post the output of "lspci -vvx" for your card.
You should see something like

00:03.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
        Subsystem: Technotrend Systemtechnik GmbH: Unknown device 0003
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 64 (3750ns min, 9500ns max)
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at e1001000 (32-bit, non-prefetchable) 
[size=512]
00: 31 11 46 71 06 00 80 02 01 00 80 04 00 40 00 00
10: 00 10 00 e1 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 c2 13 03 00
30: 00 00 00 00 00 00 00 00 00 00 00 00 0b 01 0f 26

Oliver


-- 
Info:
To unsubscribe send a mail to ecartis@linuxtv.org with "unsubscribe linux-dvb" as subject.