[linux-dvb] Pinnacle PC TV Sat, nothing on dvr0

[Vincent Bernat <bernat@free.fr>]

Hello !

I try to use a Pinnacle PC TV Sat with a fresh 2.6.7 kernel. I use
szap to tune the card :

./szap -c channels-conf/dvb-s/Astra-19.2E -r -l UNIVERSAL n24

After a few seconds, I get :

status 1f | signal 8f8f | snr 02db | ber 00000008 | unc bfff0000 | FE_HAS_LOCK

If I launch mplayer with

mplayer -ao null -vo aa - < /dev/dvb/adapter0/dvr0, I get nothing (the
cache fill is stuck at 0%).

Here is the dmesg :

Linux video capture interface: v1.00
bttv: driver version 0.9.14 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
PCI: Found IRQ 10 for device 0000:00:0a.0
PCI: Sharing IRQ 10 with 0000:00:0a.1
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 10, latency: 64, mmio: 0xdf040000
bttv0: detected: Pinnacle PCTV Sat [card=94], PCI subsystem ID is 11bd:001c
bttv0: using: Pinnacle PCTV Sat [card=94,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=009f00fc [init]
bttv0: using tuner=-1
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 . ok
bt878: AUDIO driver version 0.0.0 loaded
bt878: Bt878 AUDIO function found (0).
PCI: Found IRQ 10 for device 0000:00:0a.1
PCI: Sharing IRQ 10 with 0000:00:0a.0
bt878(0): Bt878 (rev 17) at 00:0a.1, irq: 10, latency: 64, memory: 0xdf042000
attach: checking "SMBus Via Pro adapter at 5000"
attach: checking "bt878 #0 [sw]"
find by pci: checking "bt878 #0 [sw]"
attach: "bt878 #0 [sw]", to card 0
DVB: registering new adapter (Pin).
DVB: registering frontend 0:0 (Conexant CX24110 with CX24108 tuner, aka HM1221/HM1811)...
bttv0: IRQ lockup, cleared int mask [bits: GPINT*]

Any idea ?
-- 
BOFH excuse #345:
Having to manually track the satellite.